联系我们|网站地图

新宝5平台登陆app欢迎您的来访!
当前位置:万灵科技 > 技术资料 > > 地磅遥控器安装注意事项

地磅遥控器安装注意事项

来源: 地磅遥控器 编辑:新宝5手机App 时间:2018-07-05 21:48 
地磅遥控器安装非常简单,但也要注意以下几点:
Loadometer remote installation is very simple, but also should pay attention to the following points:
1.安装拆卸地磅遥控器之前,都应该关掉电源,防止整个线路不畅通的情况给领受器芯片通电,电压不稳都可能直接烧坏芯片.就比如我们的手电机池拆卸之前先关机一样。
1. before installation and disassembly of remote control, should turn off the power, to prevent the line does not flow to the receiver chip power, voltage instability can be directly burnt like chips. Before we remove the first electric machine pool off the same.
2.如果在通电的情况下安装,接线则先接信号线,再接电源线;如图先接绿白,后接黑红。外置对插则先连接传感器端,电子遥控器再接仪表端。如图:按顺序接。
2. if in the case of electricity installation, wiring is first connected to the signal line, then the power line; figure first green and white, with black and red. The external plug is connected to the sensor and the electronic remote is then connected to the instrument terminal. As shown: in order.
3.内置对插芯片则要认清板子上的仪表端和传感器端,有中文标记,不要插反了,而且在仪表里面拔插头要小心点,不要把插头指针搞断了。
3. built-in plug-in chip, you should recognize the dashboard on the end of the instrument and sensor side, there are Chinese markers, do not plug in, and in the instrument to unplug the plug to be careful, do not plug the needle to break.
4.安装好后仪表开机,等待仪表归零后,按一下遥控8号键,仪表仍是0便可以进入调试状态了。大家永远要记住的是,按8号键必须归零。
4. after installation of instrument boot, wait for instrument zero, press the remote control button 8, the instrument is still 0 can enter the debug state. We will always remember, press the button 8 to zero.
杰出的安装使用习惯也可有效延长的使用寿命,遇到任何不懂的地方。
Good habits are the installation can effectively prolong the service life of the remote control, do not know where any.http://www.hxwaihui41.cn


文章信息归新宝5手机App所有
http://www.hxwaihui41.cn/view-137-1.html 转载请注明出处